Flagship Flags
(800)253-5247
San Diego, California

If you don't see a black vertical frame, click  here ,then select Large Pole Accessories from the black frame.

 

Back to Flagpole Accessories page

Internal Halyard Trucks

STATIONARY TRUCK

For use on rope style internal halyard flagpoles, a Single Sheave Stationary Truck is modified by adding a small pulley assembly within the truck to allow the halyard to feed from inside the flagpole. The assembly slips over the top of the shaft and is secured by three 1/4"-20NC stainless steel set screws. The minimum inside diameter of the top of the shaft should be 2 3/16". Top of the assembly is tapped 1/2''-13NC to accept a finial. Maximum recommended halyard diameter is 5/16".

Pole Top Diameter MDL Matte Finish
3"  TRK-9901 45.00
3 1/2"        TRK-9911 61.00

 

REVOLVING TRUCK - SMALL

Proportioned for use on flagpoles up to 35' with a top diameter of up to 3 1/2''. Of heavy cast construction, this truck is available in two styles in order to be used in different applications. The standard unit has integrally cast upper and lower bearing races with 25 stainless steel ball bearings. A heavy duty version uses upper and lower stainless steel, sealed lubricant bearing assemblies for longer life and greater ease of rotation. Both models are available for use with cable or can be used in halyard applications with the addition of a hard rubber grommet at the cable exit hole. Assembly is 5 3/4'' in height and 5 3/4'' in diameter. The cast aluminum spindle is threaded 1 1/4'' NPT and the top of the truck is threaded 1/2''-13NC to accept a finial.

Pole Top Diameter Max. 31/2" (Small) MDL   Matte
Revolving Truck for a Cable Standard TRK_9670  Stainless Steel Bearings on a cast bearing race $145.00
Revolving Truck for a Cable Heavy Duty TRK_9650  Dual Sealed Bearing assemblies $201.00
Revolving Truck for Rope  Standard TRK-9680 Stainless Steel Bearings on a cast bearing race $145.00
Revolving Truck for Rope  Heavy Duty TRK_9660 Dual Sealed Bearing assemblies $201.00

 

REVOLVING TRUCK - LARGE AND EXTRA LARGE

The Large and Extra Large internal halyard units are of heavy cast aluminum construction with a bronze bushing at the cable exit point. These trucks incorporate upper and lower stainless steel, sealed lubricant bearing assemblies. The Large Truck has a base diameter of 8'' and the Extra Large Truck has a base diameter of 10''. Tops are tapped 1/2''-13NC for the attachment of a finial. The standard cast aluminum spindle on each unit is threaded 1 1/4'' NPT. For Stainless Steel Spindle options in 1 1/4'' NPT and 1 1/2'' NPT spindle thread sizes, refer to Truck Options & Accessories. 

Pole Top Diameter Max 41/2"(Large)

MDL   Matte Finish
Revolving Truck for a Cable  TRK_9800 Dual Sealed Bearing assemblies 320.00

Pole Top Diameter Max 71/2" (Ex-Large)

MDL Dual Sealed Bearing assemblies Matte Finish
Revolving Truck for a Cable TRK_9900 Dual Sealed Bearing assemblies 490.00

Back to Flagpole Accessories page

courtesy fci